Resources
Location, video or sensor data: what does the project need
Match the operating question to the information, devices and connection conditions
Write the question you need to answer before listing devices. A location, an image, a temperature value and a door-state signal provide different information and require suitable hardware and software arrangements.
| Question | Information and checks |
|---|---|
| Where is the vehicle or asset? | Location, journey and time records. Check power, reporting, network and software. |
| What happened in this area? | Images or video from the relevant view. Check camera, recording, storage and viewing. |
| Did temperature or humidity change? | Measurement values. Check range, accuracy conditions, interface, power and receiver. |
| Did a door or object move? | A state signal. Check sensor version, fitting and a compatible receiver. |
Swipe horizontally to read the full table
Check the type of camera output
The current waterproof serial camera captures and transfers JPEG images using a serial protocol. Continuous-video requirements need a suitable video device and configuration. The word “camera” alone does not identify the recording method.
Match sensors to the receiving device
The temperature/humidity sensor uses RS485 and Modbus-RTU; the Hall-effect door sensor has a wired logic-level output. Confirm receiver support, supply requirements, protocol and the software presentation. A matching interface name alone does not establish complete compatibility.
For example, a transport project may need location to show where the asset is and temperature to show the measured condition. If an unloading-area view is also required, define that camera and viewing requirement separately. This is a requirements example, not a tested customer deployment.